Do you need to get a new recliner? Is the padding on your current chair torn and worn out? If so, this post is for you! In this article, we will go step-by-step through how to add padding to a recliner.
The process is simple and can be done in one day or less by someone with no sewing experience. So grab some supplies from the store and follow these instructions for how to add padding to a recliner!
Steps on Adding Pad to a Recliner
Step One: Purchase a foam mattress topper
This is the first step in how to add padding to the recliner that you should take. The easiest way would be purchasing a good quality foam mattress pad at your local store, but if you want something even better and more durable, these are some options for purchase below! You will want to buy a foam mattress pad that is at least the same size as your recliner.
Step Two: Remove the old padding from your chair
The next step in how to add padding to recliners would be removing the old, worn out, and torn upholstery fabric or stuffing. This can be done with an iron and a seam ripper, or a razor to remove the old padding.
Step Three: Cut and Sew your new fabric for your chair
The third step in how to add padding to this recliner would be cutting out your new upholstery fabric that is big enough to cover the bottom of the cushion on all four sides by at least 12 inches.
If you are planning on using the same fabric for all four sides, cut your fabric with a 45-degree angle on one of the short ends and then open it up to create an “X”. You will need two panels that measure 36″ by 55″. This is so they can fold in half and meet at the seam.
Step Four: Sew the new fabric to the old cushion with a zigzag seam
The next step is sewing your new upholstery fabric onto the back of your recliner, this has been done by using a zigzag stitch and stitching along all four sides around 12 inches from where you started on one side. When you are done sewing the fabric to one side, make sure that you sew over your stitches with a zigzag stitch in order to secure them.
The next step is attaching the new upholstery fabric around all four sides of the recliner by using a zigzag stitch again so it can be securely attached and measure 12 inches from where you started on one side.
Measure 36″ by 55″ panel of fabric and cut to size, then lay out the panels so they measure 45 inches by 55″. Zigzag stitch around all four sides with a zigzag seam about 12 inches from where you began sewing on one edge.
When you are done sewing one side, make sure that you sew over your stitches with a zigzag stitch in order to secure them, and then attach it around all four sides by using a zigzag seam so they can be securely attached.
How do you fix a sunken recliner?
In order to fix a sunken recliner, you will need to screw casters onto the bottom of each leg. You may want to attach them using screws and nuts on an angle so that they are hidden from view by attaching them into the side paneling when done.
Alternatively, if your chair does not have any legs or is too high off the ground, you can use furniture sliders under each leg.
Remove any chair pads or cushions and then place a piece of plywood on top of the seat cushion before putting it back in its original position.
Secure tightly with screws if necessary to make sure that it does not move around again.
How long should a Lazy Boy recliner last?
A recliner should last about 15 years on average.
However, if your Lazy Boy has a cracked frame or any other major structural damage, then it is more likely that the chair will no longer be able to hold up well and you may need to get another one sooner than usual.
It’s also worth noting that when used for long periods, the upholstery can wear out.
This means that you may need to replace it after a while or else end up with an uncomfortable chair on which to sit for hours.
How do I know when my Lazy Boy recliner needs replacing?
If your Lazy Boy is too uncomfortable and will not stay in place, then it is likely that the upholstery has worn out and needs to be replaced.
Another telltale sign of a recliner nearing its end is if you notice small tears forming or pieces coming off.
This may happen because of how long your chair has been used without having any maintenance done on it.
If you have a Lazy Boy recliner that is too uncomfortable, then it may be time to replace the upholstery. There are two ways in which this can happen: through natural wear and tear or when using it for long periods without doing maintenance on it.
The telltale sign of your chair nearing its end is if you notice small tears forming or pieces coming off.
This may be because of how long your chair has been used without any maintenance done on it.