This blog post will teach how to clean a Baby Trend double jogging stroller so that it doesn’t take over your life in the process!
If you are a parent, then chances are that you have owned a Baby Trend double jogging stroller. It may seem like this is one of the simplest things to clean up, but it can be surprisingly difficult if you don’t know what to do.
Steps on How Clean a Baby Trend Double Jogging Stroller
Step 1. Use a rag or microfiber cloth to wipe down the frame of your Baby Trend stroller. Be sure to use some water and vinegar on stubborn stains so that you don’t have any sticky residue left behind.
Step 2. Wipeout each cup holder with dish soap and warm water, then scrub it clean using an old toothbrush or small nailbrush. You can also replace the cups if they are old enough!
Step 3. Take off all four wheels/casters by lifting from underneath them to access the wheel wells where dirt collects most often; this is usually done via a quick-release lever which may need to be lifted slightly for access depending on what model you own. Spray these areas down with cleaning products and then scrub with a clean, old toothbrush.
Step 4. Lift the stroller’s seat cushion to access the underside of it; spray this down as well and make sure that you get all parts of the fabric.
Step 5. Take off any attachments such as rain shields or sun canopies by loosening their connection points and wiggling them free without touching anything else on the frame!
Make sure not to forget these when mounting/dismounting your machine from its base because they are often forgotten about during washing time but very important for safety (or just go ahead and wash those too).
Now is also a good opportunity to spot-check wheels for rust issues if you have yet to do so and apply new lubrication if needed.
Step 6. Set the frame on a sheet of plastic to protect it from spillage then remove any remaining fabric items such as trays, bows or seat covers by grasping them tightly at their connection points (or touching anything else) with two hands to grab an edge between your fingers and firmly pull up until you feel resistance; slacken one hand’s grip while keeping the other firm to avoid tearing before using both hands together for final removal!
Step 7. Disconnect all connections that may otherwise be covered by water during washing – don’t worry about this step if already disconnected earlier but double-check just in case!
If applicable: Locate, twist off and discard air valve plug; replace the valve with a new one, if desired. Locate and remove the front wheel assembly by pulling it straight out from under the stroller’s frame; replace or repair as needed before reattaching to the frame
Fill the sink up with cold water and add some gentle dish soap or laundry detergent (about 0.31 fluid ounces) – just enough for a thin layer on top of the surface!
Place stroller in soapy water, giving each side an adequate scrub down using your hands but avoid touching any joints that are likely to have dirt build up like at hinges where wheels meet legs; rinse thoroughly until all suds are gone then move onto final steps below!
Rinse off brush attachment with cold water and gently scrub at any remaining dirt spots; rinse again then allow to air dry! Take a clean, soft towel or dishcloth and run it along with the rubber wheels.
How often should you do this?
A good rule of thumb is once every month but if your baby has been on lots of long walks with their stroller that day, then by all means go ahead and get in there for an extra thorough cleaning sooner than later so they don’t have to deal with dirty wheels while running!
Keep in mind these steps are for the Baby Trend double jogger model only – other models will vary slightly from what we’ve shown today!
How do you put a baby trend jogging stroller in a car seat?
If your seat is a backless car seat (ex. Graco Comfort Sport): you will need to find the label on the bottom of the stroller base that says “do not install” and place it in between their front wheels, like so:
Otherwise, if your child’s car seat is installed at eye level, then you can just put them together! How convenient! Just line up both seats with each other – make sure all straps on both pieces are securely fastened before pushing down into lock position. Now buckle baby trend jogging stroller cup holder onto the side of one or more appropriate type and enjoy being out there while they nap in style!
How Do You Put Air In A Stroller Tire?
If your child’s car seat is installed at eye level, then you can just put them together! How convenient! Just line up both seats with each other – make sure all straps on both pieces are securely fastened before pushing down into lock position.
Now buckle baby trend jogging stroller cup holder onto the side of one or more appropriate type and enjoy being out there while they nap in style! What about the tires though? It might feel like it needs air when you push it, but don’t worry. You can inflate them by using a hand pump or an electric one if you have access to power outlets and extension cords!